header
October 29th 2007
archived under: Crafts, Decor, Home & Garden, Step by Step Crafts

I’ve been wanting to re-cover my office chair for a while… to match my bulletin board.

Then, this post from Design*Sponge reminded me recently, and I finally got off my butt to do it. However… I wish I had a chair like theirs, because the top part (the part your back leans on) on mine cannot completely snap out of the plastic frame. WISH IT COULD.

Also… I am very much a visual learner. SO… I like to cater to visual learners too. I needed WAY more photos than two “after” shots. So here is my version.

To begin: One Ugly Office Chair

Turn it over, and unscrew the seat from the base. Very simple, indeed.

Rip off the ugly useless cardboard if you feel like it, then lay the seat on your fabric, making sure the fabric is facing the right way if it is patterned.

Staple the straight sides using a staple gun.

Don’t work clockwise or counter-clockwise… work with opposing sides (like left, then right, then top, then bottom).

After that, pull each corner point as far in as it can go…

and staple the four corners with one staple each.

At each corner, now you have two “pockets” of fabric. Put your finger in the center of each pocket, then flatten it to the bottom of the seat to make a pleat. Staple each pleat.

Now you will have two pleats at each corner, for a total of eight.

Do some extra stapling wherever you feel it’s necessary, then trim your fabric pretty close to the staples, but not too close.

Now, cut a piece of muslin about the size of the chair bottom. Folding the edges under, staple the fabric to cover up the edges of your pretty fabric. Again, do top, bottom, right, left (or similar).

I folded the corners under separately too, because I felt like it.

Feel around for the screw-holes and then poke some holes in the muslin with a pair of scissors.

Now you’re ready to screw on the base again. (See the holes?)

So… screw it on!

If you’re lucky, like the folks at Design*Sponge, you will be able to pry the backrest of your chair off for its makeover. If you’re unlucky like me, you’ll need to use some biceps. I borrowed some biceps for my chair-prying.

The backrest doesn’t actually pop off… it’s still connected in the middle. So this stinks.

But it’s workable. Lay your backrest on some fabric, or some fabric on the backrest, and trace around it. Then cut around the tracing, giving yourself several inches on all sides. LEARN FROM MY ERROR: leave more wiggle room than I did! It will make life MUCH easier.

Make a running-stitch around the edge of your backrest fabric with some heavy thread (I used embroidery floss). The thread color doesn’t matter, because no one will see it.

Sit the fabric on the backrest, and pull the string to gather. If you’re lucky, you’ll get to tie the string ends together when it’s nice and gathery. If you’re unlucky, like me, your string will break.

Starting at the bottom, and working your way up both sides (and then to the top of course), tuck the fabric edges in-between the cushioned part and the plastic part of the chair back. A flat-head screwdriver is good for this. Then, snap the plastic back in place (just squeeze really hard and it’ll snap).

Voila! Your office chair is no longer ugly!





Kristin (1 comments)

I sure hope you don’t mind, but I linked your tutorial to my blog post (my very first blog post!). I also recovered an ugly office chair, and used your tutorial to help me through! Thanks so much for such a great post!!! :)
Kristin recently posted… Ugly office chair re-do: NO SEW!




Lacey S. (1 comments)

I need to do this immediately–my cats just broke one of those glass Galileo thermometers, and there are teensy shard of glass in the seat fabric. One thing I might add: If the chair could use a little more padding, buy some thick batting or thin foam, and add it before you measure your fabric. I think I’m going to cover mine in oilcloth (for spill/cat-related messes).




Helsj (1 comments)

Wow – that was so easy! Thanks for the instructions – genius. Am now feeling very productive on my maternity leave!




Hari (1 comments)

Awesome tutorial. Thanks much!




Reine (1 comments)

Thanks! :) I have been meaning to do this for ages! Now that I have a great, easy to follow tute I might actually get to it … maybe after the wedding .. lol




ipad 3 wallpaper (1 comments)

I relish, lead to I discovered exactly what I used to be having a look for. You have ended my 4 day long hunt! God Bless you man. Have a nice day. Bye




Sometimes, blogging is a bit tiresome specially if you need to update more topics.,,:’”




Theresa Forge (1 comments)

Just followed your awesome tutorial. My chair was gross and now its like new!! Thank you.




tor (1 comments)

this is great, I didn’t think the internet would hold the answer to my ugly chair dilemma but there it was! I’m going to try as soon as I can, thanks for the pictures I too need plenty of visuals!




Michelle (1 comments)

Brilliant idea! Our office chairs are so ugly. And I’m trying to make the office pretty right now and could not figure out what to do with the chairs without buying new ones. I hope it will work for mine!!




pokerfacebook (1 comments)

Neat blog! Is your theme custom made or did you download it from somewhere? A design like yours with a few simple tweeks would really make my blog jump out. Please let me know where you got your theme. Thanks a lot




Karen (1 comments)

Great Job!!! Also thanks for the great instructions.




boston (1 comments)

Thanks for the tips. I had purchased fabric to cover my chair and thought that I would have to sew a slipcover. I didn’t think that I could take the chair apart, but followed your instructions. I used upholstery tacks instead of staples since I had taken a reupholstery class several years ago and did not bother covering with muslin since the plastic base covers the bottom of the chair. It didn’t seem as if the back of the chair would come off, so I just used a small bamboo spatula to push the fabric behind the cushion and it worked beautifully! It took less than 10 minutes since I skipped the stitching. The chair was recovered in much less time than I had planned and it looks much better than I thought it would. Thanks again!




Curtain Panels ยท (1 comments)

when using desk chairs, i would always prefer to use wood instead of plastic desk chairs ,”,




Barbara (1 comments)

What a great make-over! THANK YOU SO MUCH for the wonderfully clear photos and directions, and glitches to avoid. We’ve been stuck with having one of these chairs in our living room for a temporary home office – now I can’t wait to cover it!




Jeni (1 comments)

I love this post. I have a horribly ugly chair too, and I don’t think the back rest comes out either. I will try to remember this and link back to you if I ever get around to doing it.




Charles Davis (1 comments)

i like to use wooden desk chairs in comparison with those plastic ones,,~




Anon (1 comments)

I thought the after picture was the ugly chair… x.x




Victoria (2 comments)

Brilliantly clear – thank you!




Victoria (2 comments)

Brilliantly clear – thank you!




Pilar (1 comments)

Thank you so much for the instructions! Especially the pictures. My own set of “biceps” has been fighting me tooth and nail on this – telling me that my chair is not meant for recovering and that it can't be done. Now I have proof that it can!




JoyfulAbode (1044 comments)

Using upholstery or drapery fabric is good. A little heavier weight is probably a good plan.
And yes, the muslin on the bottom is just to cover the edges and make it a bit neater looking.

Good luck and have fun!




JoyfulAbode (1044 comments)

Using upholstery or drapery fabric is good. A little heavier weight is probably a good plan.
And yes, the muslin on the bottom is just to cover the edges and make it a bit neater looking.

Good luck and have fun!




JoyfulAbode (1044 comments)

That's all right… I guess if that fabric is tacky I like some tacky stuff occasionally. :)




JoyfulAbode (1044 comments)

That's all right… I guess if that fabric is tacky I like some tacky stuff occasionally. :)




JoyfulAbode (1044 comments)

Thanks! I liked it too. It matches my homemade bulletin board too (link at the top of the post).




JoyfulAbode (1044 comments)

Thanks! I liked it too. It matches my homemade bulletin board too (link at the top of the post).




JoyfulAbode (1044 comments)

You're welcome! It really does make a difference in the way the room looks and feels. I hope you enjoy your newly-covered chair. :)




Gigi (1 comments)

Thanks for doing all the hard work, now it'll be easy for me to do. :)




Dawn (1 comments)

Nice job! I liked the fabric. Coordinates nicely with the wall color behind it adding a pop of color and pattern without overwhelming.




Anny (1 comments)

I think you actually ended up making it uglier. That fabric is super tacky.




Sarah (1 comments)

Does the fabric have to be of a certain quality or type? I have plenty of pretty patterns at home, but I think they would be too thin to wear well on a seat bottom.
And why the muslin? Is it to cover up the fabric edges on the bottom?

Thank you for posting this, I've been wanting to do this for awhile, I was just too new and too scared to the world of sewing to attempt it on my one computer chair.




Cathy (2 comments)

Thanks for this amazing tutorial!!!
You have totally inspired me to do this with my really old and ugly office chair :)




Kristen (1 comments)

Thanks for the great tutorial! I finished this today, and now I love my old office chair!




Michelle (1 comments)

I love your i borrowed some biceps. lol
very cute idea!!!




Shaky (8 comments)

How wonderful! Ok, I got my list and I’m off the door to go get all the stuffs I need for this. My husband thinks I’m crazy! lol
P.S~> Thank you for thinking of the visual people like me and adding all this pictures to your tutorials. :thumbs up: ;)




Patty (3 comments)

A couple of years ago, my friend made cute covers for her desk chair but she sewed them. I don’t sew so I gave up on making covers for my chair. Thank you so much for sharing how to do this! I’m going to attempt it this week.




yayanana (122 comments)

VERY cool. I like how you (unlike me) put the fabric on the backrest behind the plastic. Go you!




Wendy (41 comments)

That’s GREAT! I seriously want to do that to my dining room chairs!




Sarah (18 comments)

bravo! that looks awesome!




pfirsch (2 comments)

I read the post at Design*Sponge, too, but I couldn’t “see” how they were doing it. Thanks for the photo tutorial!




mub (25 comments)

I want to cover my entire house in that fabric! It’s fabulous!!! Ok, maybe not the entire house, but lots of it ;)






Leave a Reply



Your Comment



CommentLuv badge





social social social social social social social social


© 2014 Joyful Abode | Designed by OSN